HP Vectra 486VL User Manual download pdf (Page 20)

Configuration

_________________________________________________________________

MIC 2 User’s Manual Page 4 - 8

III) BARCODE MENU

1 ) STARTING BARCODE CONFIGURATION

If you want to configurate the MIC using barcode menus, first connect a

reader to MIC and install it in a terminal as described in “Installation”,

then you only have to scan the new desired parameters.

The default parameters are mentioned all along the “Barcode

Configuration” section with a “*” beside the corresponding bar code.

__________Configuration under RS232 device_______

To configurate the MIC with RS232 devices the ENTER/EXIT RS232

configuration barcode should be read before starting configuration.

Once you have changed all the parameters you need to read again this

code in order to keep on working.

When you are in this mode a special “End selection RS232 MODE”

must be used in the numeric keypad appendix D.

ENTER/EXIT RS232

____________AUTO RS232 CONFIGURATION____________

To match the MIC with the RS232 device read the following label

just after the second beep when the MIC is powered.(You have

3 secondes to read this label)

AUTO RS232

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 117 118

No comments

HP Vectra 486VL User Manual Page 20