HP rp2400 Technical Information download pdf (Page 13)

HP rp2400 Series of Servers - Basic Cable Connections

Console Connection and Configuration

Chapter 1

NOTE If you enter N when the

Save all? (Y/N)

prompt appears, the changes will take effect, but will be lost if the terminal is reset or

powered off.

HP700 VT-100 Mode Configuration

The following procedure outlines the steps to configure the HP700 series terminal for VT-100 operation.

NOTE You may use either the arrow keys or the tab key to move between the setting options on the

screen.

Be sure to save any configuration changes you make before proceeding to a new menu.

1. Press

[User System] key.

2. Press

[config keys] function key. [f8]

3. Press [terminal config] function key. [f5]

4. Move to Terminal ID and enter “vt100”.

5. Move to TermMode and, using the

[Prev] and [Next] keys, select “EM100”.

6. Save the configuration.

[f1]

7. Press the [config keys] function key. [f8]

8. Press the [ansi config] function key. [f6]

9. Move to multipage and, using the [Prev] and [Next] keys, select “yes”.

(Enables screen scrolling).

10. Move to Backspace Def and, using the

[Prev] and [Next] keys, select “Backspace/Del”.

11. Move to EM100 ID and, using the

[Prev] and [Next] keys, select “EM100”.

12. Save the configuration.

[f1]

rp24xx Server Optional PCI Web Console Cable Setup

The following describes how to install the cabling for the optional built in (PCI) web console:

• Connect the 25-pin end of the A5159-63001 adapter cable to the 25-pin connector on the Console/UPS Port

located on the rear of the rp24xx server.

• Connect the 9-pin, “Console”, connector of a A5159-63001 adapter to a A5858-63001 adapter.

Plug the other end of the A5858-63001 adapter to the 9-pin connector on the optional built-in PCI web console

card.

1 2 ... 8 9 10 11 12 13 14

No comments

HP rp2400 Technical Information Page 13