HP ML330 - ProLiant - G3 Specifications download pdf (Page 18)

Removal and Replacement Procedures

Front Bezel

CAUTION: To prevent equipment damage or data loss, be sure that the server is powered

down, all cables are disconnected from the back of the server, and the power cord is

disconnected from the grounded (earthed) AC outlet before removing the front bezel.

To remove the component:

1. Power down the server. Refer to “System Power Down” in this chapter.

2. Pull up on the bezel locking latch until it disengages.

3. Rotate the bezel upward and slide it away from the chassis. A small amount of force may

be necessary to detach the bezel.

To replace the component, reverse the removal procedure.

IMPORTANT: When replacing the front bezel, be sure to place the top hinge points in the chassis

before rotating the front bezel downward to its original position.

HP ProLiant ML330 Generation 3 Server Maintenance and Service Guide 2-5

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 79 80

No comments

HP ML330 - ProLiant - G3 Specifications Page 18