HP Compaq t5730 Thin Client User's Guide download pdf (Page 20)

Removing and Replacing the Side Access Panel and Metal

Side Cover

Removing the Side Access Panel and Metal Side Cover

WARNING! Before removing the side access panel, ensure that the thin client is turned off and the

power cord is disconnected from the electrical outlet.

To remove the access panel:

1. Remove the secure compartment cover (1). For more information, see

Removing the Secure USB

Compartment Cover on page 12.

2. Remove the access panel screw in the secure USB compartment that secures the access panel

to the chassis (2).

3. Slide the access panel about 6.35 mm (1/4 inch) toward the rear of the unit (3), and then lift the

access panel up and off the unit (4).

Figure 2-3 Removing the side access panel

To remove the metal side cover:

NOTE: Do not remove the metal side cover when installing a PCI Expansion Module.

You must remove the metal side cover to access internal components such as the battery or the memory.

1. Remove the four screws that secure the metal side cover to the chassis (1).

14 Chapter 2 Hardware Changes

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

No comments

HP Compaq t5730 Thin Client User's Guide Page 20