HP SCSI Host Bus Adapters Installation Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 18
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
Hardware and Software Installation Procedure
Network Configuration Worksheet
12
Network Configuration Worksheet
Fill out one worksheet for the networking data of each LAN port on the combination card you are installing.
Note 1: To configure values permanently, edit the configuration files using SAM or an editor such as “vi”.
Using lanadmin will not preserve your settings across reboots.
Note 2: The speed configuration of the card can be 10, 100, or 1000Mbps and is determined by the speed
setting of the hub or switch port to which the card is connected. The card automatically senses this speed. The
Base-T ports only run at one speed at a time. To verify the speed selection, run lanadmin -x ppa#.
Table 2 Network Configuration Worksheet
Data Type
Required/
Optional
Default
How to Configure
(see Note 1)
Example
Your
System
Internet
Address
Required 0.0.0.0 SAM or ifconfig or
edit
/etc/rc.config.d/
netconf
196.6.20.2
Subnet mask Required if
using
subnetting
Subnet mask not used SAM or ifconfig or
edit
/etc/rc.config.d/
netconf
255.255.248.0
Station
address
Built-in but can
be optionally
changed
As shown on card SAM or edit
/etc/rc.config.d/
hpietherconf or
temporarily:
lanadmin -A
0x0060b0c4012f
Host name
alias for this
network
interface (card)
Required if the
system is
connected to
more than 1
network
None SAM or edit
/etc/hosts
host1
Link
configuration
Required Autonegotiating SAM or temporarily:
lanadmin -X
lanadmin -X
auto_on ppa#
(if already
turned off)
Link
speed/duplex
mode
Required Autonegotiating Hub or switch (see
Note 2) SAM or
temporarily:
lanadmin -X
lanadmin -X
100fd ppa#
MTU
(Maximum
Transmission
Unit): Jumbo
Frames
Optional 1500 bytes SAM or edit
/etc/rc.config.d/
hpietherconf or
temporarily:
lanadmin -M
lanadmin -M
9000 ppa# (see
Note 3 below)
Receive flow
control
Optional On SAM or edit
/etc/rc.config.d/
hpietherconf or
temporarily:
lanadmin -X
lanadmin -X
fctrl off
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments