HP JetDirect 300X User Manual download pdf (Page 52)

46 TCP/IP Configuration

To set configuration parameters, you must set up a Telnet

connection from your system to the HP JetDirect print server.

1. Type the following at the system prompt:

telnet <IP address>

where

may be the assigned address from

BOOTP, RARP, DHCP, the printer control panel, or the default

IP address. The default IP address is 192.0.0.192. The

is listed on the JetDirect configuration page.

2. When the server responds

connected to IP address

, press

[Enter]

twice to make sure that the Telnet connection is

initialized.

3. If you are prompted for a password, type the correct password.

By default, Telnet does not require a password, but you can set

up to a 14-character password by using the password command

(passwd). Once a password is set, password protection is

enabled. You can disable password protection by typing

(zero)

when prompted for a new password, or by performing a cold

reset on the print server.

Note Any time during the Telnet session you can type:

then press

[Enter]

to view available configuration

parameters, the correct command format, and a list

of additional commands to display. To print current

configuration information, type

then press

[Enter]

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 163 164

No comments

HP JetDirect 300X User Manual Page 52