HP JetDirect 300X User Manual download pdf (Page 29)

TCP/IP Configuration

Introduction

To operate properly on a TCP/IP network, the HP JetDirect print

server must be configured with valid TCP/IP network configuration

parameters, such as an IP address. Depending on your printer and

system, this can be done in the following ways:

Note When shipped from the factory, the HP JetDirect

print server has no IP address. If the HP JetDirect

print server is not configured with a valid IP

address within two minutes after power up, a

factory default value of 192.0.0.192 will be

automatically assigned. This address must be

reconfigured with a valid address for use on your

TCP/IP network. For more information on TCP/IP

networks, see appendix A.

●

By downloading the data from a network-based UNIX server

using BOOTP (Bootstrap Protocol) and TFTP (Trivial File

Transfer Protocol) each time the printer is turned on.

Note The BOOTP daemon, bootpd, must be running on a

BOOTP server that is accessible by the printer.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 163 164

No comments

HP JetDirect 300X User Manual Page 29