Connecting a Modem and Terminal
1. Use a full-duplex, asynchronous (character-mode) modem only. The following
modems have been tested at their rated speeds:
– HP 37212B Support Link
– HP 35031A Support Link II
– HP 50759A Support Link
– Hayes 1200 Smartmodem
– Racal Vadic Maxell 2400VP (Hayes 2400 compatible)
– Black Box V.32 9600 Baud.
2. Configure the modem as described in appendix C, “Modem Configuration”.
3. Connect the modem to the console port using an RS-232-C modem cable. (For pin-outs
and recommended cables see appendix A, “Cables and Connectors”.)
4. At the remote site, connect the terminal, or PC emulating a terminal, to the remote
modem. Make sure the terminal and modems are functioning properly, then establish
the link between the terminal’s modem and the hub’s modem according to the modem
instructions.
5.
Press RETURN several times for the prompt =>. The baud rate for communication
between the hub and the terminal is set automatically when you press RETURN.
2-12 Installation
Comments to this Manuals