HP Fiber-Optic Hub Plus User's Guide download pdf (Page 24)

To attach an ST-type connector:

1. Remove the plastic dust covers, if present, from the cable’s connector and the hub’s

receptacle.

2. Align the small key on the inner shaft of the cable’s connector with the slot at the

bottom of the hub’s receptacle.

3. Push in to slide the key into the slot. Then twist the outer cap clockwise until the two

keys at both sides of the receptacle fit into the two slots on the cap. Continue to push in

and then twist clockwise until the keys are held in the cap’s slots.

To remove an ST-type connector from a receptacle:

1. Grasp the outer cap with thumb and forefinger above and below. (It is easier to fit

either your thumb or forefinger between the horizontal rows of receptacles, than to fit

your fingers between connectors at left and right.)

2. Push in and twist the cap counterclockwise. This releases the receptacle’s keys from

their slots at both sides.

3. When the keys are released, pull the connector until it is completely free. Use dust

covers on connectors and receptacles that are not in use.

2-8 Installation

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 83 84

No comments

HP Fiber-Optic Hub Plus User's Guide Page 24