HP Firewall Series Installation Manual download pdf (Page 19)

Step2 Plug the transceiver module into the SFP port of the firewall, as shown in Figure 12.

Figure 12 Install the transceiver module

To unplug the transceiver module, you should move the pull latch to the horizontal position, and then pull

the transceiver module out.

Step3 Remove the dust cap from the transceiver module and the protective caps from the fibers.

Step4 Plug the LC connectors on one end of the fiber cable into the Rx and Tx ports, and plug the LC connectors

on the other end to the Tx and Rx ports on the peer device, as shown in Figure 13.

Figure 13 Connect the fi

ber connectors

Step5 After the firewall is powered on, check whether the LEDs of the optical interfaces are normal. If the LED

is steady on, you can be sure that the link is connected. For more information about the LED status, see

the chapter “Appendix B LEDs.”

NOTE:

By default, the copper port of a combo interface works. You can use the combo enable { copper | fiber

}

command in interface view to chan

e the workin

port. For more information about the command, see

the command references for the firewalls.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 59 60

No comments

HP Firewall Series Installation Manual Page 19