HP Firewall Series Installation Manual download pdf (Page 30)

Item Description

HTTP

Specify whether to enable HTTP on the device, and set the HTTP port number.

Enabled by default.

IMPORTANT:

• If the current user has logged in to the web interface through HTTP, disabling HTTP

or modifying the HTTP port number will result in disconnection with the device;

therefore, perform the operation with caution.

• When you modify a port number, ensure that the port number is not used by

another service.

HTTPS

Specify whether to enable HTTPS on the device, and set the HTTPS port number.

HTTPS is the HTTP protocol that supports the Secure Sockets Layer (SSL) protocol. It

can improve device security. For more information about HTTPS.

Disabled by default.

IMPORTANT:

• If the current user logged in to the web interface through HTTPS, disabling HTTPS

or modifying the HTTPS port number will result in disconnection with the device;

therefore, perform the operation with caution.

• When you modify a port number, ensure that the port number is not used by

another service.

• By default, HTTPS uses the PKI domain default. If this PKI domain does not exist, the

system will prompt you for it when the configuration wizard is completed; however,

this will not affect the execution of other configurations.

Configuring the IP address for an interface

Click Next on the service management configuration page to enter the interface IP address configuration

page, as shown in Figure 26. T

he table lists the IP address configuration information for all Layer 3

Ethernet interfaces and VLAN interfaces. You can click a value in the table and then modify it. Only when

the IP configuration is Static Address, can you configure the IP address and mask.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 59 60

No comments

HP Firewall Series Installation Manual Page 30