HP MSR93x Installation Manual download pdf (Page 11)

Figure 3 Mounting the router on a workbench

Installing the router on a wall

CAUTION:

hen mountin

the router on a wall, position the router so the network interfaces face downwards, and

the sides with ventilation openings are perpendicular to the ground, as shown in Figure 4.

To mount the router on a wall:

1. Mark the locations of the two mounting holes on the wall with the separations listed as follows:

Router model Se

aration

JG511A, JG512A, JH012A, JG513A, JG596A, JG665A, and

JG704A

180 mm (7.09 in)

JG514A, JG515A, JG531A, JG516A, JG517A, JG518A, JG519A,

JH013A, JG520A, and JG597A

240 mm (9.45 in)

The holes must be level (on the same horizontal line).

2. Drill two holes in the wall.

3. Following the marks, drill the two holes at least 22 mm (0.87 in) deep.

Verify that the holes are level.

4. Insert an anchor into each hole so it is flush with the wall surface.

5. Drive a screw into each anchor, keeping the screw heads protruding at least 1.5 mm (0.06 in)

from the wall.

6. Hang the router on the screws.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 66 67

No comments

HP MSR93x Installation Manual Page 11