HP 5/xx User Manual Page 51

  • Download
  • Add to my manuals
  • Print
  • Page
    / 140
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 50
English 39
3 How to Install Accessories In Your PC
Installing Mass Storage Devices
5 Connect the power cable and the data cable to the rear of the drive.
The connectors are shaped to go in one way only.
6 Install any other accessories before replacing the cover. Reconnect
all cables and power cords.
Connecting an IDE
Device to a Data Cable
There are two different data cables for IDE devices. The first is marked
“HDD” next to the system board attachment and has two drive
connectors. The middle connector of this data cable must be connected
to the bootable or master hard disk drive. The second has only one drive
connector which is red and marked “CD-ROM” next to the system board
attachment.
Up to three IDE devices can be connected to the system board using
these data cables.
After Installing an IDE
Drive
After installing an IDE drive, you will need to run Setup to confirm that
the drive has been detected by the PC. Refer to “After Installing an IDE
Drive” on page 64.
Power cable
Data cable
uno.bk : uno3_ins.fb4 Page 39 Monday, July 21, 1997 12:46 PM
Page view 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 139 140

Comments to this Manuals

No comments