Hp ProDisplay P201 20-inch LED Backlit Monitor User Manual download pdf (Page 11)

Connecting the Cables

1. Place the monitor in a convenient, well-ventilated location near the computer.

2. Remove the cable management clip from the stand by pulling outward on the two sides of the clip

(1), then lifting the clip off the stand (2).

Figure 2-3 Removing the Cable Management Clip

3. Connect a VGA signal cable or DVI-D signal cable (select models).

NOTE: The monitor is capable of supporting either analog or digital input (select models). The

video mode is determined by the video cable used. The monitor will automatically determine

which inputs have valid video signals. The inputs can be selected by pressing the +/source button

on the front panel or through the On-Screen Display (OSD) feature by pressing the Menu button.

●

For analog operation, use the VGA signal cable provided. Connect the VGA signal cable to

the VGA connector on the rear of the monitor and the other end to the VGA connector on the

computer.

●

For DVI digital operation, use the DVI-D signal cable provided. Connect the DVI-D signal

cable to the DVI connector on the rear of the monitor and the other end to the DVI connector

on the computer.

4. Connect one end of the provided audio cable to the audio connector on the monitor (select

models) and connect the other end of the cable to an audio output connector on the rear panel of

the computer.

Connecting the Cables

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

No comments

Hp ProDisplay P201 20-inch LED Backlit Monitor User Manual Page 11