Hp 110 User Manual download pdf (Page 69)

Reverse this procedure to install the TouchPad button board.

Display assembly

NOTE: For a complete list of display assemblies, refer to Display components on page 25.

Before removing the display assembly, follow these steps:

1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn

the computer on, and then shut it down through the operating system.

2. Disconnect all external devices connected to the computer.

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet

and then unplugging the AC adapter from the computer.

4. Remove the battery (see

Battery on page 44).

5. Remove the service door (see

Service door on page 45).

6. Disconnect the WLAN antenna cables from the WLAN module (see

WLAN module on page 46).

7. Disconnect the WWAN antenna cables from the WWAN module (see

WWAN module

on page 47).

8. Remove the keyboard (see

Keyboard on page 53).

9. Remove the top cover (see

Top cover on page 56).

Remove the display assembly:

1. Close the computer.

2. Position the computer upside down, with the front toward you.

3. Remove the back corner rubber feet (1).

4. Remove the two Phillips M2.0x5.0 screws (2), one beneath each rubber foot.

5. Remove the plastic rear corner covers (3).

NOTE: The rear corner covers are included in the Plastics Kit, spare part number 652308-001.

Component replacement procedures 61

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 103 104

No comments

Hp 110 User Manual Page 69