HP 3C900 User Manual download pdf (Page 27)

4 Connecting to a Windows NT Server 4.0

Windows 95 SR2

Windows 95 SR2 Requirements

• HP Vectra with Windows 95 SR2.

• 3COM Etherlink 3C900 Ethernet card and drivers disk Ver. 2.1.

Driver Name: El90X.DOS Size: 45KB Date: 3/21/97

• Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/

IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.

Device Configuration

• Network Driver Optimization Normal

• Full Duplex Auto Select (N-WAY)

• Boot PROM Disabled

• Media Type Auto Select (N-WAY)

• I/O Base Address FCC0h (PCI)

• Interrupt Request Level 9 (PCI)

Procedure

1 With the HP Vectra turned off, install the 3COM Etherlink 3C900 adapter

card into an PCI slot.

2 Connect network Cable media to the 3COM 3C900 card.

3 Insert a DOS bootable diskette and power on the machine.

4 After booting, insert the 3COM drivers disk 1 “Etherlink 3C900 Ethernet

Drivers Ver. 2.1.” and execute “A:\3C90XCFG.EXE.”

5 Select “Configure NIC,” and verify the resource settings listed above

under the heading “Device Configuration.”

6 If changes are required, save those changes and exit.

7 Remove the 3Com Software driver diskette and reboot the machine.

8 When Windows 95 restarts a message will appear that new hardware has

been found.

9 Insert 3Com Etherlink 3C900 software disk 1 of 2 ver 2.1.

10 Click “Next” to begin hardware wizard on the “Update Device Driver

Wizard” dialog message.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

No comments

HP 3C900 User Manual Page 27