HP 3C900 User Manual download pdf (Page 21)

3 Connecting to a Windows NT Server 3.51

Windows NT Workstation 4.0

Windows NT

Workstation 4.0

Requirements

• HP Vectra with Windows NT Workstation 4.0 Service Pack 3.

• 3COM Etherlink 3C900 Ethernet card and drivers disk ver 2.1.

• Driver Name: 3C90X.INF Size: 71KB Date: 11/25/96

Microsoft Windows NT Workstation 4.0 and Service Pack Media.

(If you have a Hewlett-Packard pre-loaded HDD, the media is located at

“C:\I386”)

• Microsoft Windows NT Server 3.51 machine that supports Net BEUI, TCP/

IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.

Device Configuration

• Network Driver Optimization Normal

• Full Duplex Auto Select (N-WAY)

• Boot PROM Disabled

• Media Type Auto Select (N-WAY)

• I/O Base Address FCC0h (PCI)

• Interrupt Request Level 9 (PCI)

Procedure

1 With the HP Vectra turned off, install the 3COM Etherlink 3C900 PCI

adapter card into a PCI slot.

2 Connect network media to the 3COM 3C900 PCI card.

3 Insert a DOS bootable diskette and power on the machine.

4 After booting, insert the 3COM Etherlink 3C900 Ethernet card and drivers

Disk 1 Ver. 2.1. and execute “A:\3C90XCFG.EXE.”

5 Select “CONFIGURE NIC,” and verify the resource settings listed above

under the heading “Device Configuration.”

6 If changes are required, save those changes and exit.

7 Remove the 3com cards driver diskette and reboot the machine.

8 Power on the machine and allow it to boot to Windows NT Workstation

4.0.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

No comments

HP 3C900 User Manual Page 21