HP JETDIRECT 400N User Manual Page 82

  • Download
  • Add to my manuals
  • Print
  • Page
    / 96
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 81
4-14 Control Panel for Large-Format Printers
For the 700/2000/2500/3000/3500 Series Printers
1. Access the configuration menu (see To enable or disable
network protocols in this chapter).
2. From the
CFG ETALK=NO
menu item, press
[Enter]
,
,
[Enter]
to display
CFG ETALK=YES
.
3. Press
to display the current phase parameter. To change the
setting, press
[Enter]
,
,
[Enter]
.
4. To save the configuration, print a configuration plot by pressing
the two arrow keys simultaneously. Your printer configuration
is now active.
To manually configure other parameters, see the appropriate
sections in this chapter. To complete the print server configuration,
see the HP JetDirect software installation guide included with the
product.
Configuring the Timeout for End-of-Job
Sensing for the HP DesignJet 600 Series
When installed in an HP DesignJet 600 Series printer, the
HP JetDirect card provides a
JOB TIMEOUT
parameter. For
networks with multiple network protocols, the
JOB TIMEOUT
parameter specifies the time that the HP JetDirect card remains
connected to an active network protocol even though no print jobs
are received on that protocol. After that time, the card allows
access by another protocol.
To set the JOB TIMEOUT
parameter
If you havent already done so, access the network configuration
menu following the instructions described in To enable or disable
network protocols in this chapter.
1. Verify that your printer displays
STATUS
and
Ready to plot
.
2. Press
[Enter]
until
MENUS
(
FULL MENUS
on the 650C printer)
and
Plot mgmt
appear.
3. Press
repeatedly until
MENUS
and
I/O setup
appear.
4. Press
[Enter]
to access the MIO slot.
I/O SETUP
and
Modular
appear.
5. Press
[Enter]
.
MIO SETUP
and
CFG NETWORK=NO
appear.
Page view 81
1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 95 96

Comments to this Manuals

No comments