32
Interfaces:
eth0 (mtu: 1500)
eth1 (mtu: 1500)
eth2 (mtu: 1500)
eth3 (mtu: 1500)
eth4 (mtu: 1500)
eth5 (mtu: 1500)
eth6 (mtu: 1500)
eth7 (mtu: 1500)
eth8 (mtu: 1500)
Global default-gateway:
Enabled: no
Global mtu:
Enabled: yes
Global VLANs:
Enabled: yes
Interfaces:
vlan14 (id: 14, if: eth0)
*hp-gateway2 [memgate-cluster: master] (config) #
Next, set the gateway cluster interface to be the VLAN created above:
# cluster interface vlan# <where # is the VLAN-ID #>
# write memory
Refer to the ‘VLAN Cluster Interface’ section of the ‘HP VMA SAN Gateway Installation and
Configuration Guide’ for additional details and examples.
*hp-gateway2 [memgate-cluster: master] (config) # cluster interface vlan14
*hp-gateway2 [memgate-cluster: *unknown*] (config) # write memory
hp-gateway2 [memgate-cluster: *unknown*] (config) # show network
Networking configuration:
Bonded interface eth0:
Enabled: yes
Interfaces:
eth1
eth2
Jumbo frames:
Enabled: no
Interfaces:
eth0 (mtu: 1500)
eth1 (mtu: 1500)
eth2 (mtu: 1500)
eth3 (mtu: 1500)
eth4 (mtu: 1500)
eth5 (mtu: 1500)
eth6 (mtu: 1500)
eth7 (mtu: 1500)
eth8 (mtu: 1500)
Global default-gateway:
Enabled: no
Global mtu:
Enabled: yes
Global VLANs:
Enabled: yes
Interfaces:
vlan14 (id: 14, if: eth0)
*hp-gateway2 [memgate-cluster: *unknown*] (config) # write memory
Comments to this Manuals