Preventive MaintenanceC4705-90000
4-3
The drive roller cleaning procedure should be performed only
by HP trained personnel: otherwise personal injury may occur.
If ink is spilled on the drive roller, remove the ink. Due to the ink's reflectance, ink on the
roller can disrupt the plotter's edgeĆsensing function. To remove any ink from the roller,
perform the following procedure:
Connect the plotter to an ac power source.
Hold the button down and switch the plotter ON.
Using the arrow buttons, scroll to the menu display, then press the
button.
Using the arrow buttons, scroll to the submenu display.
Simultaneously press the and the buttons to access the
menu.
Using the button, scroll to reach the following display:
SERVICE TESTS
22 X Motion control
Press the button, and the following display will appear:
REMOVE MEDIA
PRESS ENTER
Remove any media from the plotter.
Raise the window. Holding the window sensor down with a pen, pencil or small
screwdriver, press the button. The display will show that the arrow buttons can be
used to control the roller speed for cleaning. Press the button several times
until the drive roller reaches a convenient speed for cleaning.
The speed of the roller can be reduced or increased by pressing the appropriate arrow button.
Apply any common household cleaning solution (water based only) to a soft, lintĆfree rag
and apply it to the drive roller surface while it is rotating. Thoroughly clean the roller
surface.
Stop the roller by pressing the button when you have finished cleaning.
Press the button to return to the SERVICE TESTS menu display.
Using the button, scroll to the display.
Allow the drive roller to dry before inserting media in the plotter.
Comments to this Manuals