Hp 700 User Manual download pdf (Page 154)

Full menu mode

only

Utilities

Accuracy

Recalibrate

Full menu mode only

Utilities

Accuracy

Restore factory

7-6

Company confidential. Murillo/Ravillo User’s Guide. Final Freeze Status: Frozen

This is the cyan on page 7-6 (seq: 152)

This is the black on page 7-6 (seq: 152)

To Recalibrate the Plotter

1 Choose your media type (sheet or roll). If recalibrating for a non-standard media

type, use that type. Otherwise, HP Matte Film will give greatest accuracy.

2 Choose your media size. Sheet media must be either E/A0 or D/A1.

3 Go to

Recalibrate in the front-panel menus, as shown above left.

4 Choose

Create pattern. The message Calibrating is displayed. If sheet media is

loaded, this will be ejected. If roll media is loaded, you are asked to remove it.

5 When prompted, load your media, using the normal procedure. If using sheet

media, load it in portrait orientation, unless you chose D/A1-size media for an

E/A0-size plotter, in which case load it in landscape orientation.

6 When the calibration plot is finished, remove it.

7 Unload any unplotted media.

Rotate the calibration plot 90_ counterclockwise and reload it printed side

down, so that the black arrows go into the plotter first. NOTE: Even if you

selected roll media in step 5, this time you must select sheet media.

123

0030

9 Go to Recalibrate again and, this time, choose Measure pattern.

10 When the plotter has finished measuring and has ejected the sheet, STATUS/Ready

is displayed. The recalibration routine is finished.

To Restore the Factory’s Calibration

From the Accuracy menu, choose Restore factory. That’s all.

Reconfiguring Your Plotter

Recalibrating the Plotter for Accuracy

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 221 222

No comments

Hp 700 User Manual Page 154