Hp DL380 G7 User Manual download pdf (Page 26)

Operations 26

1. Power down the server if performing a non-hot-plug installation or maintenance procedure ("Power

down the server" on page 24).

2. Extend the server from the rack (on page 24).

3. Use the T-15 Torx screwdriver attached to the rear of the server to loosen the security screw on the hood

latch.

4. Lift up on the hood latch handle, and then remove the access panel.

Install the access panel

1. Place the access panel on top of the server with the hood latch open. Allow the panel to extend past the

rear of the server approximately 1.25 cm (0.5 in).

2. Push down on the hood latch. The access panel slides to a closed position.

3. Use the T-15 Torx screwdriver attached to the rear of the server to tighten the security screw on the hood

latch.

Access the product rear panel

Cable management arm with left-hand swing

To access the server rear panel:

1. Remove the cable arm retainer.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 125 126

No comments

Hp DL380 G7 User Manual Page 26