Hp ProLiant BL465c G7 Server-Blade User Manual download pdf (Page 10)

Component identification 10

Mezzanine connector definitions

Item PCIe

Mezzanine connector 1 x8, Type I mezzanine card only

Mezzanine connector 2 x8, Type I or II mezzanine card

System maintenance switch

Position Function Default

1* iLO 3 security override Off

2 Configuration lock Off

3 Reserved Off

4 Reserved Off

5* Password disabled Off

6* Reset configuration Off

7 Reserved Off

8 Reserved Off

9 Reserved Off

10 Reserved Off

*To access redundant ROM, set S1, S5, and S6 to ON.

System maintenance switch procedures

When you perform troubleshooting steps, this guide may instruct you to perform the following procedures:

• Clear the system configuration ("Clearing the system configuration" on page 10).

• Access the redundant ROM ("Accessing the redundant ROM" on page 11).

To complete these procedures, you must change physical settings on the system maintenance switch.

Clearing the system configuration

RBSU can be used to restore the factory default configuration. For more information, see "HP ROM-Based

Setup Utility (on page 50)." If the system is unable to boot into RBSU, use the following steps to clear the

system configuration:

1. Power down the server blade (on page 13).

2. Remove the server blade (on page 14).

3. Remove the access panel (on page 15).

4. Change position 6 of the system maintenance switch to on.

5. Install the access panel (on page 15).

6. Install the server blade in the enclosure and power up the server blade.

7. Wait for the POST message that prompts you to change the switch setting:

Maintenance switch detected in the "On" position.

Power off the server and turn switch to the "Off" position.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 97 98

No comments

Hp ProLiant BL465c G7 Server-Blade User Manual Page 10