HP NetServer LH 6000 Service Manual Page 31

  • Download
  • Add to my manuals
  • Print
  • Page
    / 114
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 30
Chapter 2 System Information
25
To configure the drive(s) in the hot-swap cage as a RAID array:
Run HP NetRAID Assistant to configure one or more RAID logical drives. Select "Execute" on
the Configure Disk Array screen to start the HP NetRAID Assistant.
Refer to the Integrated HP NetRAID Controller Configuration Guide for further configuration information.
Processors Guidelines
The installation procedure is the same for the rack-mount and the pedestal HP NetServer once you gain
access to the system board assembly
Configuration Switches S1-S4 – CPU Speed
Speed Switch 1Switch 2Switch 3Switch 4
550 MHz ON OFF OFF OFF
600 MHz OFF ON ON ON
650 MHz OFF ON ON OFF
700 MHz OFF ON OFF ON
750 MHz OFF ON OFF OFF
NOTE Not all processor speeds are supported.
1
2
3
4
5
6
1
2
3
4
5
6
Processor
Processor
RM
Locations
Processor and VRM Locations
Page view 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 113 114

Comments to this Manuals

No comments