HP NetServer LH 6000 Service Manual download pdf (Page 100)

Chapter 6 Replacing Parts

Replacing the Hot Swap Mass Storage Cage

The hot-swap mass storage cage has two printed circuit boards (PCBs) mounted on the cage. In the

occurrence of a failure, the entire cage, along with the PCBs, must be replaced.

To replace the cage:

1. Back up the hard disk drive(s) and save the configuration.

2. If necessary, shutdown the network operating system.

3. Turn off the HP NetServer and display.

4. Disconnect all telephone cables and power cords.

5. Remove the bezel and the appropriate cover(s).

6. Unlock the mass storage cage lock.

7. Remove all disk modules from the hot-swap cage.

CAUTION Note and mark the order of the installed hard disk drive modules in the hot swap

cage so that you install them later in the exact same order. Failure to do this may

result in serious data-corruption problems.

8. Disconnect all power cords and cables from the hot-swap drive cage.

9. Remove the two screws (accessible after removing the appropriate cover and air baffle)

securing the side of the cage to the chassis.

Remove cage mounting screws

10. Remove the six screws securing the cage to the front of the chassis.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 113 114

No comments

HP NetServer LH 6000 Service Manual Page 100