HP 11i User Manual download pdf (Page 17)

/dev/dsk/c138t3d0 /dev/rdsk/c138t3d0

NOTE: The third column represents the hardware path of the slot in which the adapter is

installed. The hardware path is different for each installed adapter.

If an installed Fibre Channel adapter requires the fclp driver and the appropriate driver

does not appear as shown above, the driver is not installed.

If the ioscan output is similar to the following:

fc 0/0/2/1/0 UNCLAIMED UNKNOWN

HP-UX detected the adapter, but the drivers are not properly loaded.

If the correct driver is installed, but the adapter does not show in the ioscan output, the

driver is not recognizing the adapter.

3. If the ioscan output indicates a problem, contact HP for assistance.

Verifying Connectivity

Once your HP Fibre Channel Mass Storage software and hardware are installed and running,

follow these steps to verify connectivity:

1. Check the state of all Fibre Channel hardware and interfaces. Enter the ioscan command

and verify that the Hardware State and the HW-Interface State are CLAIMED.

If the Fibre Channel device file has not been created, enter the following commands:

# insf -e

# ioscan -f

2. Verify that all devices you attached to the Fibre Channel adapter are listed in the ioscan

output. For example, if you have a direct attach Fibre Channel device attached to the system,

the ioscan output may look like the following:

8/12.8.0.255.0.1.0 sdisk CLAIMED DEVICE DGC C3400WDR5

The example above is the hardware path of LUN0 of a directly attached Fibre Channel Mass

Storage device with Loop ID of 1. For details on interpreting hardware paths for Fibre

Channel devices, see “Interpreting Hardware Paths” (page 18).

If all attached devices are not listed or appear as UNCLAIMED, see the Troubleshooting and

Maintenance chapter of this guide.

Verifying Connectivity 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 38 39

No comments

HP 11i User Manual Page 17