HP 501 802.11ac Wireless Client BridgeInstallation GuideAbstractThis document describes the procedure to install and initially configure the HP 501 80
2. Power on the HP 501 by powering on the PoE switch, power injector, or by plugging in theAC/DC adapter.Initially, the HP 501 power LED flashes amber
server. The HP 501 Ethernet MAC address is printed on the HP 501 label identified as MACADDR, and listed on the management tool Home page as MAC addre
4. Reconnect your computer to the HP 501.5. Confirm that your wireless network interface is still disabled (it was disabled during an earlierconfigura
4 Support and other resourcesContacting HPFor worldwide technical support information, see the HP support website:http://www.hp.com/supportBefore cont
Table 2 Document conventions (continued)ElementConventionMonospace text• File and directory names• System output• Code• Commands, their arguments, an
5 Documentation feedbackHP is committed to providing documentation that meets your needs. To help us improve thedocumentation, send any errors, sugges
A Regulatory informationFor important safety, environmental, and regulatory information, see Safety and ComplianceInformation for Server, Storage, Pow
санымен жəне т.т. көрсетіледі. Айларды 1 мен 9 аралығындағы сандар көрсетеді:1 саны қаңтарайы үшін, 2 саны ақпан айы үшін жəне 9 саны қыркүйек айы үші
© Copyright 2013 Hewlett-Packard Development Company, L.P.The information contained herein is subject to change without notice. The only warranties fo
Contents1 Getting started...4Overview...
1 Getting startedThe HP 501 (J9835A) is a dual band 802.11a/b/g/n/ac Wireless Client Bridge. It securelyconnects legacy Ethernet or serial communicati
AntennasThree dual-band antennas are included with the HP 501. Optional outdoor antennas are available.Table 1 Supported antennasImpedience(Ohms)Numbe
2 Installing the HP 501The HP 501 is suited for indoor installation on a desktop, wall, ceiling, or in a plenum. The enduser is responsible for ensuri
Wall or ceiling installationWhen mounting the HP 501 on a wall or ceiling, ensure that the mounting surface and the fastenersyou use can support at le
2. Slide the HP 501 base onto the mounting bracket, and then place it on the desktop.Figure 4 Desktop installation2. Mounting bracket1. HP 501NOTE: Do
3 Initial configurationThis chapter describes how to configure a factory-default HP 501. The sample configuration linksa wired computer to a private n
Comments to this Manuals