HP 501 Wireless Client Bridge Installation Manual download pdf (Page 7)

Wall or ceiling installation

When mounting the HP 501 on a wall or ceiling, ensure that the mounting surface and the fasteners

you use can support at least 0.9 kg (2 lb). Allow extra weight for cables.

WARNING! Areas above false ceilings can contain dangerous electrical cabling, gas pipes,

and other hazards. Make whatever safety arrangements are needed to ensure that you can work

safely above the false ceiling. HP recommends that you use a non-conductive step ladder such as

one made of fiberglass.

1. Hold the mounting bracket against the wall or ceiling where it will be installed. Mark two

holes for the screws (wall anchors).

2. Drill two holes for the wall anchors, typically 4.7 mm (3/16 inch) in diameter.

3. Insert the anchors and tap them flush with the wall or ceiling surface.

4. Use the mounting screws to attach the spring clips and mounting bracket to the wall or ceiling.

5. Attach the three antennas to the HP 501.

6. Align the tab slots on the back of the HP 501 with the retention tabs on the mounting bracket.

Figure 3 Wall mount

3. Mounting bracket1. Screws and wall anchors

4. HP 5012. Spring clips

7. Slide the HP 501 onto the mounting bracket until it is fully engaged.

Do not let go of the HP 501 until you confirm that it is firmly in place.

NOTE: Do not power on the HP 501 until directed to do so.

8. Proceed to “Initial configuration” (page 9).

Desktop installation

1. Attach the three antennas to the HP 501.

Wall or ceiling installation 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 16 17

No comments

HP 501 Wireless Client Bridge Installation Manual Page 7