HP EN 5000 Digital Media Receiver User Manual download pdf (Page 41)

user’s guide 37

If DHCP is not enabled, you will need to assign a static

address to your media receiver. Take note of the IP

Address and Subnet Mask listed by the ipconfig

utility, and see “wired with static address” on

page 38.

Note: If you cannot tell how your network addresses

are assigned, then try dynamic address (DHCP) first.

The media receiver will display an error message if it is

unable to dynamically configure its address.

wired home network

In a wired home network, all computers are connected

to a network hub or router. This may also act as a

cable/DSL modem for sharing an internet connection.

wired with dynamic address

Connect the media receiver to your router, just as you

would one of your computers. In almost all cases, the

router works as a DHCP server (i.e., it assigns network

addresses).

Set the media receiver network settings to wired using

DHCP addressing. From the main home screen:

1. Press options

2. Select Network Setup

3. Set Connection to Wired (Ethernet)

4. Select Address

5. Set Configuration to DHCP

6. Press left arrow to return to receiver options

7. Select Apply Changes to apply the network

changes

hub or router

Lexus.book Page 37 Monday, January 6, 2003 2:00 AM

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 67 68

No comments

HP EN 5000 Digital Media Receiver User Manual Page 41