HP ProDesk 400 G5 Base Model Microtower PC User Manual download pdf (Page 56)

Connector board

Follow these steps to remove the connector board:

1. Prepare the computer for disassembly (see Preparation for disassembly on page 28).

2. Remove the access panel (see Access panel on page 29), and then remove the following components:

a. Front bezel (see Front bezel on page 32)

b. WLAN module (see WLAN module on page 38)

c. Solid-state drive (see Solid-state drive on page 39)

d. Drive cage (see Drive cage on page 33)

e. Fan-sink (see Fan-sink on page 43)

f. System board (see System board on page 46)

Remove the connector board:

1. Remove the two Phillips PM2.0×3.5 screws (1) that secure the connector board to the system board.

2. Remove the connector board (2).

NOTE: When the connector board is removed, make sure the connector board bracket does not become

separated from the board.

Reverse this procedure to install the connector board.

48 Chapter 4 Removal and replacement procedures

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 125 126

No comments

HP ProDesk 400 G5 Base Model Microtower PC User Manual Page 56