HP LASERJET 2600 User Manual

HP Color LaserJet 2600 series -- Maintenance Kit Instructions www.printertechs.com Please note that installing the fuser in this maintenance kit is

12 Open two (2) clips and remove one (1) clip to remove the fuser connector.1 Open clips2 Remove clip1 Fuser connector2 Remove clip from the board by

13 Unplug two (2) 3-pin optical encoder wires.14 Unplug the red high-voltage bias wire.15 Remove the thermistor wire.ENWW Removal and replacement proc

16 Remove the cables from the wiring harness.17 Remove three (3) screws from the fuser chassis.1 Three (3) screws18 Gently rocking if necessary, roll

Use the following procedure to replace the fuser.1 Align the fuser tabs with their respective holes.2 Complete replacement by following steps 1 throug

Paper pickup roller removal and replacementUse the following procedures to remove the paper pickup roller.1 Open the front door.2 Remove the print car

3 Remove two (2) screws.1 Two (2) screws4 Remove the pre-transfer guide (RC1–5419–000CN).5 Use a small screwdriver to pull back on the tabs.90 Chapter

3 Remove two (2) screws from the right cover assembly (RM1–1858–000CN).1 Two (2) screws4 Remove the right cover assembly, carefully disengaging the ca

6 Insert a screwdriver to loosen the release tab on each side of the upper face cover.7 Remove the upper face cover (RC1–5174–000CN).8 Remove four (4)

9 Lift up and remove the face-down cover (RC1–5173–000CN).10 Remove the output tray by releasing the tabs.1 Release tabs11 Unplug the harness from the