
3. On the right side of the product, remove the grounding spring (callout 1), disconnect one
connector (callout 2), release two tabs (callout 3), and then remove the main fan.
Figure 1-51 Remove the fan (1 of 2)
1
3
2
Reinstallation tip When reassembling the main fan to the duct, make sure that the fan cable
(callout 1) is positioned as shown in the figure below. Also, make sure that the label (callout 2) on
the fan is facing inside.
Figure 1-52 Remove the fan (2 of 2)
1
2
40 Chapter 1 Removal and replacement ENWW
Comments to this Manuals