HP Compaq WF1907 User Manual download pdf (Page 20)

Setting Up the Monitor

4–6 User’s Guide

7. Follow the instructions that are included with the mounting fixture to ensure that the monitor is safely attached.

The four-threaded mounting holes that are on the back of the panel are compliant with the VESA standard for

mounting flat-panel monitors. The vp15 monitor uses the 75 mm spacing standard, while the other models use the

100 mm spacing standard.

Use the four holes to attach a swing arm or other mounting fixture.

To reinstall the desktop pedestal and base for the monitor

1. Remove the mounting fixture.

2. Reverse the preceding instructions.

Connecting the VGA (Analog) and/or DVI-D (Digital) Cable

Use a VGA cable or a DVI-D cable (provided with select models). To use DVI, you must have a DVI-compliant

graphics card. Connectors are located at the back of the monitor. Be sure the computer and monitor are turned off

and unplugged.

Connecting the VGA or DVI-D cable—connector locations may vary

To connect the VGA cable

Connect one end of the VGA video cable to the back of the monitor and the other end to the VGA video connector

on the computer.

To connect the DVI-D cable

Connect one end of the DVI-D video cable to the back of the monitor and the other end to the DVI video connector on

the computer. Your computer must have a DVI-compatible graphics card installed for use with this cable. Monitor

DVI-D connector and cable are included on select models only.

VGA DVI

VGA

DVI

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

No comments

HP Compaq WF1907 User Manual Page 20