10. If it is necessary to replace the display panel cable:
a. Release the display panel cable from the retention clip (1) built into the left hinge.
b. Release the display panel cable from the retention clips (2) and routing channel built into the left
side of the display enclosure.
c. Release the grounding tape (3) that secures the display panel cable to the display enclosure.
d. Disconnect the display panel cable (4) from the webcam/microphone module.
e. Remove the display panel cable.
The display panel cable is available using spare part number 917431-001 and includes
the webcam/microphone module cable.
11. If it is necessary to replace the display hinges:
a. Remove the four Phillips PM2.4×3.6 broad head screws (1) and the four Phillips PM1.9×3.4
screws (2) that secure the display hinges to the display enclosure.
b. Remove the display hinges (3).
The display hinges are included in the Display Hinge Kit, spare part number 917434-001.
c. Remove the three Phillips PM1.9×3.4 screws (4) that secure the display panel bracket to
the display enclosure.
Component replacement procedures 41
Comments to this Manuals