HP G2 Service Manual download pdf (Page 28)

5. Remove the Phillips PM1.4×3.6 screw (1) and the Phillips PM1.4×2.2 broad head screw (2) that

secure the connector board to the display panel assembly.

6. Remove the connector board (3).

Reverse this procedure to install the connector board.

System board

Description Spare part number

System board equipped with an Intel Z2520 1.20-GHz dual core processor, a graphics subsystem with UMA memory, and

1.0-GB of system memory

Equipped with a 16-GB eMMC hard drive 790593-001

Equipped with a 8-GB eMMC hard drive 790592-001

Before removing the system board, follow these steps:

1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,

and then shut it down through the operating system.

2. Disconnect the power from the tablet by unplugging the power cord from the tablet.

3. Disconnect all external devices from the tablet.

4. Remove the back cover (see Back cover on page 12).

22 Chapter 5 Removal and replacement procedures

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 36 37

No comments

HP G2 Service Manual Page 28