When the download is completed, a flashing “COMPLETED”
message appears briefly in the status window. Then the window
closes and control returns to the NCL prompt.
If the PC host does not respond within approximately 60 seconds
after you execute Zput, the command times out and control
returns to the NCL prompt.
Note If the “Auto downloading” parameter described under “Preparation”
above has not been set to “on”, then to complete the download you must
press the [Pg Dn] key and follow the instructions in the resulting window.
For more information, refer to the PROCOMM PLUS User Manual.
For information on Zput event messages, refer to the Zmodem event
messages in the Operator’s Reference.
How To Use the Network Control Language (NCL) Commands To Manage a Router
Using PC Modem Access to Transfer Configuration and NCL Display
7-35
Comments to this Manuals