Hp Designjet L25500 Printer series User Manual download pdf (Page 35)

14. Ensure that once the media is correctly aligned with the blue stop and the right spindle hub, they

are both locked in position. Shown below is the media correctly aligned with the blue stop and the

right spindle hub.

15. Pull the substrate taut to the position shown in the following figure. Do not attempt to pull more

substrate out of the printer. Use tape to secure the substrate to the spindle core, taping it in the

center first. You may need to use more tape than is shown in the following image. The substrate

should be secure enough to support the weight of the loop-shaping core, which you insert in a later

step.

NOTE: If you are loading the take-up reel during printing you do not need to pull the substrate

taut. Tape the substrate to the spindle core when an adequate length of substrate has fed from the

printer after printing begins.

NOTE: To avoid having the substrate skew as it winds onto the spindle core, make sure the

substrate is straight when you attach it, and aligned with the input roll. It is sometimes useful to use

the core grooves to align the substrate.

16. Press the OK button on the front panel. The printer advances the substrate.

ENWW Use the take-up reel 31

Handle the substrate

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 81 82

No comments

Hp Designjet L25500 Printer series User Manual Page 35