HP VMA-series Memory Arrays User's Guide download pdf (Page 36)

36 HP VMA SAN Gateway Installation and Configuration Guide AM456-9025A

2. Log in as admin.

3. Enter enable mode, and then configure terminal with the following commands.

4. Enable bonding using the following commands:

5. Repeat steps 1 through 4 on the secondary node.

6. Reboot both HP VMA SAN Gateway nodes to reconnect the cluster.

VLAN Cluster Interface

You can hide the cluster multicast traffic using a VLAN for the cluster interface. This requires

changing network settings on your network switch. For information on how to set this up, see the

administration guide for your network switch.

> enable

# configure terminal

(config) # network bond eth0 interface eth1 interface eth2 mode balance-rr

(config) # cluster interface eth0

(config) # cluster master interface eth0

(config) # wr mem

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 82 83

No comments

HP VMA-series Memory Arrays User's Guide Page 36