HP EliteDesk 800 G1 Base Model Small Form Factor PC User Manual download pdf (Page 16)

Configuring IPv4

Select Wired LAN IPV4 Configuration and then configure the parameters shown in Figure 12.

Figure 12. Configuring the network for IPv4

– DHCP Mode: Enabled (Recommended setting; default)

If DHCP is enabled (recommended), skip to Step 16.

If DHCP is disabled, complete steps (i) – (v) of Implementing wireless connectivity for Intel AMT to configure an IPv4

static IP address for Intel AMT.

– IPV4 Address: (Network-dependent; default is 0.0.0.0 )

Specify the desired static IP address (such as 192.168.0.1). Ensure that each Intel AMT system has a unique IP

address. Multiple systems sharing the same IP address may result in network collisions that would cause the

systems to respond incorrectly.

– Subnet Mask Address: (Network-dependent; default is 255.255.255.0)

– Default Gateway Address: (Network-dependent; default is 0.0.0.0)

– Preferred DNS Address: (Network-dependent; default is 0.0.0.0)

– Alternate DNS Address: (Network-dependent; default is 0.0.0.0)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 42 43

No comments

HP EliteDesk 800 G1 Base Model Small Form Factor PC User Manual Page 16