HP Switch 2510 User Manual download pdf (Page 16)

Switch Overview

Installing the Switch

Horizontal Surface Mounting

Attach the rubber feet to the four corners on the bottom of the switch within

the embossed angled lines. Use a sturdy, horizontal surface in an uncluttered

area. You may want to secure the networking cables and switch power cord

to the table leg or other part of the surface structure to help prevent tripping

over the cords.

Caution Make sure the air flow is not restricted around the sides and back of the switch.

Flat Wall Mounting

You can mount the Switch 2510 on a wall. Please see the detailed installation

instructions in the ProCurve Series 2510 Installation and Getting Started

Guide on the ProCurve Networking Web site for more information,

www.procurve.com.

4. Connect the Switch to a Power Source

1.) Plug the included power cord into the switch’s power connector and into

a nearby AC power source.

2.) Re-check the LEDs during self test. See “Self Test LED Behavior” on page 7

5. Connect the Network Cables

Connect the network cables, from the network devices or your patch panels,

to the fixed RJ-45 ports on the switch or to any mini-GBICs you have installed

in the switch.

Note Each of the two mini-GBIC slots is shared with the associated 10/100/

1000Base-T RJ-45 port. If a mini-GBIC is installed in a slot, the associated RJ-

45 port is disabled.

If you have any mini-GBICs installed in the switch, the type of network

connections you need to use depends on the type of mini-GBICs you have

installed.

When a network cable from an active network device is connected to the port,

the port LED for that port should go on. If the port LED does not go on when

the network cable is connected to the port, See “Diagnosing with the LEDs”

on page 15.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

No comments

HP Switch 2510 User Manual Page 16