HP STORAGEWORKS A7540-96010 User Manual download pdf (Page 35)

Installing

35HP StorageWorks 2/8q Fibre Channel Switch Installation Guide

Connect the cables

■ Connect Fibre Channel devices to the switch

■ Connect power to the switch

Connect Fibre Channel devices to the switch

Connect cables to the SFP transceivers and their corresponding devices, and then apply power

to the devices. LC-type duplex fiber optic cable connectors are designed for use with the SFP

transceivers. Duplex cable connectors are keyed to ensure proper orientation.

GL_Ports self configure as FL_Ports when connected to loop of public devices or F_Ports

when connected to a single device. G_Ports self configure as F_Ports when connected to

single public devices.

Connect power to the switch

WARNING: This product is supplied with a 3-wire power cable and plug. Use this power

cable in conjunction with a properly grounded outlet to avoid electrical shock. An electrical

outlet that is incorrectly wired could place hazardous voltage on metal parts of the switch

chassis.

■ A different power cable than the one supplied may be required in some countries.

■ For 125 Volt electrical service, the cable must be rated at 10 Amps and be approved

by UL and CSA.

■ For 250 Volt electrical service, the cable must be rated at 10 Amps, meet the

requirements of H05VV-F, and be approved by VDE, SEMKO, and DEMKO.

1. Connect the power cord to the AC power port on the switch chassis and to a grounded AC

outlet or uninterruptible power supply.

2. Verify that the chassis LEDs illuminate, followed by all port Logged-in LEDs.

3. After a few moments, verify that the chassis System Fault LED is extinguished while the

Input Power LED and Heartbeat LED remain illuminated.

4. Wait approximately one minute for the POST to complete, and the following LED pattern

to begin:

— The Input Power LED remains illuminated indicating that the switch logic circuitry is

receiving DC voltage. If not, contact your authorized maintenance provider.

— The Heartbeat LED indicates the results of the POST. The POST tests the condition of

firmware, memories, data-paths, and switch logic circuitry. If the Heartbeat LED

blinks steadily about once per second, the POST was successful, and you can continue

with the installation process. Any other blink pattern indicates that an error has

occurred. See “Heartbeat LED blink patterns” on page 42 for more information about

error blink patterns.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 69 70

No comments

HP STORAGEWORKS A7540-96010 User Manual Page 35