HP LE1852ms User Manual download pdf (Page 18)

8. Secure the Thin Client power adapter by placing the adapter into in the recessed slot in the

monitor stand and pushing the adapter bracket down until it engages with the center of the

recessed slot.

Figure 2-14 Securing the Thin Client Power Adapter

Turning on the Monitor

1. Press the power button on the computer to turn it on.

2. Press the power button on the front of the monitor to turn it on.

CAUTION: Burn-in image damage may occur on monitors that display the same static image on

screen for a prolonged period of time.* To avoid burn-in image damage on the monitor screen, you

should always activate a screen saver application or turn off the monitor when it is not in use for a

prolonged period of time. Image retention is a condition that may occur on all LCD screens. Monitors

with a “burned-in image” are not covered under the HP warranty.

* A prolonged period of time is 12 consecutive hours of non-use.

NOTE: If pressing the power button has no effect, the Power Button Lockout feature may be

enabled. To disable this feature, press and hold the monitor power button for 10 seconds.

NOTE: You can disable the power LED in the OSD menu. Press the Menu button on the front of the

monitor, then select Management > Bezel Power LED > Off.

When the monitor is powered on, a Monitor Status message is displayed for five seconds. The

message shows VGA as the current active signal, the current preset display resolution, and the

recommended preset display resolution.

12 Chapter 2 Setting Up the Monitor

1 2 ... 13 14 15 16 17 18 19 20 21 22

No comments

HP LE1852ms User Manual Page 18