HP ENVY 34c 34-inch Media Display User Manual download pdf (Page 22)

3. Press the power button located underneath the right speaker to turn on the monitor.

CAUTION: Burn-in image damage may occur on monitors that display the same static image on screen for a

prolonged period of time.* To avoid burn-in image damage on the monitor screen, you should always

activate a screen saver application or turn off the monitor when it is not in use for a prolonged period of time.

Image retention is a condition that may occur on all LCD screens. Monitors with a “burned-in image” are not

covered under the HP warranty.

* A prolonged period of time is 12 consecutive hours of non-use.

NOTE: If pressing the power button has no effect, the Power Button Lockout feature may be enabled. To

disable this feature, press and hold the monitor power button for 10 seconds.

NOTE: You can disable the power LED in the OSD menu. Press the Menu button on the right side of the

monitor, and then select Power Control > Power LED > Off.

When the monitor is powered on, a Monitor Status message is displayed for five seconds. The message

shows which input is the current active signal, the status of the auto-switch source setting (On or Off; factory

default is On), the current preset display resolution, and the recommended preset display resolution.

The monitor automatically scans the signal inputs for an active input and uses that input for the display.

16 Chapter 3 Setting up the monitor

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 38 39

No comments

HP ENVY 34c 34-inch Media Display User Manual Page 22