HP D5062 User Manual download pdf (Page 23)

EnglishEnglish 21

HP L1510 15” LCD Monitor

Using Your Monitor

To access the Recall function, first select Information,thenselectRecall

from the sub-menu

WARNING

By pressing the button all previous adjustments are lost (refer to

“Adjusting Your Monitor” on page 10 to adjust the monitor again).

Setting the Amount of Displayed Information

To set the amount of displayed information, change the screen resolution

of your computer. The higher the screen resolution, the more information

you can see on the screen. It is recommended that you use a resolution of

1024 x 768. It is recommended that you use a refresh rate of 60 Hz. The

image refresh rate is the number of times per second that the image is

redrawn.

NOTE LCD technology does not cause any flicker at low refresh rates.

Minimizing Energy Consumption

If your computer supports VESA monitor power management (available

on many HP computers), you can minimize the power consumed by the

monitor. There are two power saving modes:

•

Suspend mode (uses less than 5W)

• Sleep mode (uses less than 5W)

When the monitor enters power saving mode, the message No Signal is

displayed for a few seconds before the screen blanks. In power saving

mode the front panel indicator light is amber.

To set these power saving modes, refer to the manual that came with your

computer.

Recall: If you press , factory preset

settings will be recalled. The settings that are

affected by the Recall function are

•

Screen Geometry

•

Horizontal Frequency

• Vertical Frequency

•

Brightness / Contrast

RECALL

EXIT

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

No comments

HP D5062 User Manual Page 23