HP Compaq dc5700 User's Guide download pdf (Page 37)

Installing an Internal 3.5-inch Hard Drive

NOTE The system does not support Parallel ATA (PATA) hard drives

1. Install the four guide screws (two on each side) that were removed from the old drive into the new

drive. The screws help guide the drive into its proper position in the bay. Extra guide screws are

provided on the front of the chassis under the front bezel.

Figure 2-26 Installing Hard Drive Guide Screws

NOTE There are a total of eight extra guide screws on the front of the chassis under the

bezel. Four have 6-32 standard threads and four have M3 metric threads. Standard screws

are used for hard drives and have a silver finish. Metric screws are used for all other drives

and have a black finish. Make sure to install the appropriate guide screws into the drive.

2. Slide the drive into the drive bay, making sure to align the guide screws with the guide slots, until

the drive snaps into place. The upper bay is for the primary hard drive. The bottom bay is for an

optional secondary hard drive.

Figure 2-27 Sliding a Hard Drive into the Drive Bay

ENWW Installing Additional Drives 31

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 51 52

No comments

HP Compaq dc5700 User's Guide Page 37