HP D6000 User Manual download pdf (Page 9)

Component identification 9

Item Description Status

Internal Health LED Green = System health is good.

Off = System is off.

GSI LED* Amber = Enclosure requires service

check: I/O, fan and power supply LEDs,

and AC power cables to power supplies.

Off = Enclosure is functioning normally.

UID button/LED (Drawer 2) Blue = UID LED is enabled from the UID

button.

Blue flashing = System is in hard drive

locate mode or an enclosure firmware

update is in progress.

Off = UID LED is disabled.

Power supply LED Green = Power on and power supply

functioning properly

Off = One or more of the following

conditions exists:

•

System powered off

•

AC power unavailable

•

Power supply failed

•

Power supply exceeded current limit

System fan LED Green = Normal operation

Amber flashing = Fault

Off = Fan unseated from connector or

failed

I/O module LED Green = System activity

Amber = Fault

Off = Enclosure is powered off.

7-segment display* 1 = SES overall warning

2 = Temperature sensor warning

3 = Cooling fan warning

4 = Power supply warning

5 = Host GSI enabled

6 = I/O PIC upgrade needed

7 = Power supply PIC upgrade needed

8 = CPLD upgrade needed

9 = Standby heartbeat failure

10 = Remote I/O module heartbeat

failure

11 = Enclosure thermal shutdown

imminent

12 = Enclosure thermal shutdown

occurred

13 = Enclosure management bus failure,

false fan failures may occur

14 = Signal integrity errors detected

15 = Power supply PIC communications

error

16 = Unsupported backplane detected

UID button/LED (Drawer 1) Blue = UID LED is enabled from the UID

button.

Blue flashing = System is in hard drive

locate mode or an enclosure firmware

update is in progress.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 52 53

Comments to this Manuals

No comments

HP D6000 User Manual Page 9

Comments to this Manuals

Related products and manuals for Disk arrays HP D6000