Hp LC 2000 User Manual download pdf (Page 40)

Chapter 3 Opening and Closing the HP NetServer

Removing the Pedestal

The pedestal version of the HP NetServer LC 2000 mounts to an anti-tip pedestal,

which can be easily removed, if necessary.

1. Perform Steps 1-4 in the previous section, "Removing Covers – Pedestal

(LC 2000)."

NOTE The front bezel is shown removed, but the bezel may remain on

the chassis while removing the pedestal.

2. Disconnect all cables connected to the rear of the NetServer that would

limit its rotation before continuing.

3. Turn the NetServer over onto its top and pull up on the two tabs as shown

in Figure 3-9.

Figure 3-9. Removing the Pedestal

4. Slide the pedestal to the rear of the NetServer as shown in Figure 3-9.

5. To re-install the pedestal, repeat Steps 1-3 and slide the pedestal forward

onto the NetServer.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 193 194

No comments

Hp LC 2000 User Manual Page 40