Hp Lights-Out 100 Remote Management User Manual download pdf (Page 26)

Using Integrated Lights-Out 100 26

Enter the new password by entering set password=<new password>. For example:

/./map1/accounts/user1/> set password=testpswd1

6. Enter the new password when prompted.

7. Enter a new group by entering set group=<new group name>. Valid group settings are user,

operator, and oemhp. For example:

/./map1/accounts/user1/> set group=user

Additional network settings

You can configure additional network settings using a Web browser or the CLP.

Configuring network settings using a Web browser

Click Network Settings on the main menu, and input new settings on the Network Settings screen.

Configuring network settings using the CLP

1. Log in to the remote management processor CLP as described in the "Logging in to the remote

management processor (on page 16)" section.

2. At the command prompt, enter cd map1/nic1.

3. Configure the network settings by entering the following: set <network property>=<new

setting>. Configurable valid network properties are:

• networkaddress—Specifies the IP address for the NIC. This is the dynamic setting.

• oemhp_nonvol_networkaddress—Specifies the IP address stored in non-volatile memory.

• oemhp_mask—Specifies the subnet mask for NIC. This is the dynamic setting.

• oemhp_nonvol_mask—Specifies the subnet mask stored in non-volatile memory.

• oemhp_gateway—Specifies the gateway IP address for the NIC. This is a dynamic setting.

• oemhp_nonvol_gateway—Specifies the gateway IP address stored in non-volatile memory.

• oemhp_dhcp_enable—Specifies whether DHCP is enabled for the NIC. Boolean values are

accepted

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

No comments

Hp Lights-Out 100 Remote Management User Manual Page 26