HP 9g Graphing Calculator Manual download pdf (Page 25)

E-25

You can enter numbers in base 2, base 8, base 10 or base 16. To set the

number base, press [ 2nd ] [ dhbo ], select an option from the menu and

press [ ]. An indicator shows the base you selected: d, h, b

, or o. (The

default setting is d: decimal base). See Example 49.

The allowable digits in each base are:

Binary base (b): 0, 1

Octal base (o): 0, 1, 2, 3, 4, 5, 6, 7

Decimal base (d): 0, 1, 2, 3, 4, 5, 6, 7, 8, 9

Hexadecimal base (h): 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, IA, IB, IC, ID, IE, IF

Note: To enter a number in a base other than the set base, append the

corresponding designator (d, h, b, o) to the number (as in h3).

Press [

] to use the block function, which displays a result in octal or binary

base if it exceeds 8 digits. Up to 4 blocks can be displayed. See Example 50.

Negative Expressions

In binary, octal, and hexadecimal bases, negative numbers are expressed

as complements. The complement is the result of subtracting that number

from 10000000000 in that number’s base. You do this by pressing [ NEG ]

in a non-decimal base. See Example 51.

Basic Arithmetic Operations for Bases

You can add, subtract, multiply, and divide binary, octal, and hexadecimal

numbers. See Example 52.

Logical Operation

The following logical operations are available: logical products (AND),

negative logical (NAND), logical sums (OR), exclusive logical sums (XOR),

negation (NOT), and negation of exclusive logical sums (XNOR). See Example

53.

Chapter 8 : Programming

The options on the program menu are: NEW (for creating a new program), RUN

(for executing a program), EDIT (for editing a program), DEL (for deleting a

program), TRACE (for tracing a program), and EXIT (for exiting program mode).

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 86 87

No comments

HP 9g Graphing Calculator Manual Page 25