HP HyperFabric User's Guide download pdf (Page 124)

Managing HyperFabric

Starting HyperFabric

Chapter 5110

Using the clic_start Command

Run the clic_start command on each node to start the HyperFabric

management process on that node.

If you include /opt/clic/bin in your PATH statement, you can run the

command as it is shown below. Otherwise, you must include

/opt/clic/bin as part of the command name (that is,

/opt/clic/bin/clic_start).

You must be logged in as root to run this command.

The syntax is as follows:

clic_start

The clic_start -? command can be issued to display the online help

for clic_start, or look at the clic_start (1m) man page by issuing

the man clic_start command.

If HyperFabric is already running, you will receive an informational

(FYI) message telling you so. Your reaction to this message depends on

the situation:

• If you have simply forgotten (or did not know) that HyperFabric was

already running, you do not have to do anything.

• If you have changed the HyperFabric conﬁguration with the

clic_init command or SAM, you must stop HyperFabric (by

running the clic_shutdown command or using SAM) and then start

HyperFabric (by running the clic_start command or using SAM).

See either “Using the clic_shutdown Command” on page 128 or

“Using SAM” on page 129, whichever is appropriate.

Using SAM

To use SAM to start HyperFabric on an HP 9000 system running HP-UX

11i v2, complete the following steps:

Step 1. Start SAM.

Step 2. Select the “Networking and Communications” area.

Step 3. Select “HyperFabric”.

Step 4. Pull down the “Actions” menu and select Start HyperFabric.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 189 190

No comments

HP HyperFabric User's Guide Page 124